Porsche 924 Workshop Manual page 56

34. Remove bolts for rubber/metal damper on
vehicles with automatic transmission.
35 . Lift engine out carefully by lifting and
turning at same time .
CAUTION
Lift engine carefully to avoid damaging
propeller shaft, clutch or body.
Installing
Note the following for installations .
1 . Tighten nuts and bolts to specified torques.
2. Add coolant.
3. Open heater wide.
4. Add coolant until level is at mark on com-
pensating tank.
Printed in Germany - II, 1977
Engine / Crankcase
10
5. Loosen hose clamp and remove vent plug .
6 . Start engine and run it at high idle speed
for about 1 minute. If there are
no air
bubbles in the coolant leaving the vent
opening, insert plug and tighten hose cl a mp .
7 . Check coolant level when engine is at opera -
ting temperature and add more coolant until
level is at inspection level on compensating
tank .
Removing
I
Installing Engine 10 - 7