Marine Approval (Pending); Pressure Equipment Directive 2014/68/Eu (Ped); Other Standards And Guidelines - Endress+Hauser Cerabar PMC11 Technical Information

Marine approval (pending)

Pressure Equipment
Directive 2014/68/EU (PED)
Other standards and
guidelines
44
Device
PMC21
PMP21
PMC21
PMP21
PMC21
PMP21
1) Product Configurator, order code for "Additional approval"
Pressure equipment with allowable pressure ≤ 200 bar (2 900 psi)
Pressure equipment (with a maximum allowable pressure PS ≤ 200 bar (2 900 psi)) can be classified
as pressure accessories in accordance with Pressure Equipment Directive 2014/68/EU. If the
maximum allowable pressure is ≤ 200 bar (2 900 psi) and the pressurized volume of the pressure
equipment is ≤ 0.1 l, the pressure equipment is subject to the Pressure Equipment Directive (cf.
Pressure Equipment Directive 2014/68/EU, Article 4, point 3). The Pressure Equipment Directive
only requires that the pressure equipment shall be designed and manufactured in accordance with
the "sound engineering practice of a Member State".
Reasons:
• Pressure Equipment Directive (PED) 2014/68/EU Article 4, point 3
• Pressure equipment directive 2014/68/EU, Commission' s Working Group "Pressure", Guideline
A-05 + A-06
Note:
A partial examination shall be performed for pressure instruments that are part of safety equipment
for the protection of a pipe or vessel from exceeding allowable limits (safety accessory in accordance
with Pressure Equipment Directive 2014/68/EU, Article 2, point 4).
Pressure equipment with allowable pressure > 200 bar (2 900 psi)
Pressure equipment designated for application in every process fluid having a pressurized volume of
<0.1 l and a max. allowable pressure PS > 200 bar (2 900 psi) shall satisfy the essential safety
requirements set out in Annex I of the Pressure Equipment Directive 2014/68/EU. According to
Article 13 pressure equipment shall be classified by category in accordance with Annex II. The
conformity assessment of the pressure equipment shall be determined by the category I under
consideration of the above-mentioned low pressurized volume. These devices shall be provided with
CE marking.
Reasons:
• Pressure Equipment Directive 2014/68/EU, Article 13, Annex II
• Pressure equipment directive 2014/68/EU, Commission' s Working Group "Pressure", Guideline
A-05
Note:
A partial examination shall be performed for pressure instruments that are part of safety equipment
for the protection of a pipe or vessel from exceeding allowable limits (safety accessory in accordance
with Pressure Equipment Directive 2014/68/EU, Article 2, point 4).
The following also applies:
PMP21 with threaded connection and internal process isolating diaphragm PN > 200 :
Suitable for stable gases in group 1, category I, module A
The applicable European guidelines and standards can be found in the relevant EU Declarations of
Conformity. The following standards were also applied:
DIN EN 60770 (IEC 60770):
Transmitters for use in industrial process control systems Part 1: Methods for performance
evaluation
Cerabar PMC11, PMC21, PMP11, PMP21
Designation
DNV GL
ABS
RINA
1)
Option
LE
LF
LV
Endress+Hauser