MOUNT REGULATOR
BRACKET
You will need: two 1/4-20 x 1/2 inch bolts, two nylon
washers, two 1/4-20 keps nuts, and a 7/16 inch or open
end wrench.
Position the top of the regulator bracket over the top
crosspiece. Slip a washer over the bolt and insert through
top of bracket and crosspiece. Add keps nut. Repeat with
second bolt. Tighten. Figure 4.
View from below front
Figure 4
Crosspiece
ADD RIGHT PANEL
FOR THE SUMMIT 450 & 650
You will need: right panel and two plastic plugs.
Set the right panel in place. The top flange of the panel
fits over the top crosspiece. The bottom curved flange fits
under the bottom crosspiece. Figure 5.
Top
crosspiece
Bottom
crosspiece
Once the panel is in place, push in the two plastic plugs
through the panel into the top crosspiece. Figure 6.
5
Curved flange
Figure 5
Figure 6
Top
flange