Subscribe to Our Youtube Channel
Related Manuals for UDI R/C U64
Summary of Contents for UDI R/C U64
- Page 1 USER MANUAL Suitable for indoor flight ▲ This product is suitable for users over 14 years old. ▲ Stay away from the rotating propeller. ▲ Read the<important statement and safety guidelines >carefully..
- Page 2 Ready Before Take Off Drone preparation Slider drone pattern Propeller A Propeller A Forward Charging port Charging-LED Propeller B Propeller B Drone-LED Backward Front Motorboat drone pattern Forward Charging port Front Backward...
- Page 3 Slider drone parts installation ① Wings installation ① Installation: Distinguish left and right wings, aim at the body hole to push until end. Disassembly: Right Wing Front Apply force to pull the wings out is fine. ① ② Left Wing Rear ②...
-
Page 4: Charging Instruction
Motorboat parts installation ① Slider drone doll installation Installation: Make sure distinguish the doll’s front and rear soles, put into the front toes and then press down the rear foot is fine. Disassembly: Lift the rear foot and then pull out is fine. -
Page 5: Transmitter Preparation
Transmitter preparation Auto-demo Heading Hold Mode Take Off / Landing / Speed Switch Emergency Stop Button Left stick / Right Stick Trimmer (Press down) Power Switch Motorboat / Slider drone Mode Switch Power-LED Battery installation Open the battery cover on the back side of the transmitter ，according to the "+-" electrode instruction in the battery groove, place the battery with the same type of saturated power (battery not include). -
Page 6: Flight Operation
Flight Operation Transmitter connect with Drone Frequency Pairing ① Power on the drone, the drone indicator will change from fast flash to slow flash, and enter frequency pairing. Hold the drone to keep balance. * Stay away from the propellers to avoid injury. The Motorboat are placed on the horizontal ground. -
Page 7: Left Stick
Control stick operation Left stick Go up Counterclockwise turn Go down Clockwise turn Right stick Forward Fly to the left Backward Fly to the right Take off After the frequency pairing is successful, press the "take off/land" button, the transmitter will sound "di", and the drone will automatically rises and flies at an altitude of about 1.2m. - Page 8 Auto-demo Press “Automatic show”，the drone will fly forward and turn back to the original position. Speed mode switch Press the "H/L" button, the transmitter will sound "di.di.di", to enter High Speed Mode "H". Press again, the transmitter will sound "di", to enter Low Speed Mode “L”. Press again, the transmitter will sound “di.di”, to enter Middle Speed Mode “M”.
-
Page 9: Heading Hold Mode
Heading Hold Mode The default setting is NOT Heading Hold Mode. Heading Hold Mode means that the user can operate the aircraft without having to distinguish directions. This mode is suitable for beginners, or when it is difficult to distinguish the forward and backward direction of the drone. ①... -
Page 10: Drone Calibration
Flying Trimmer Forward / Backward Trimmer During the flight, if the drone tilts forward, press down the left stick in the center button, and push the right stick backwards. Otherwise push forwards. Left and right turning trimmer Press down During the flight, if the drone head rotates to left,then press down the left stick in the center button and push the left stick to right. -
Page 11: Parts Replacement
Altitude Hold Mode Intelligent flight control system calculates the hovering position, more stable control feature, makes it easier for beginners to control. Release the stick, the drone will keep hovering automatically to enable single hand operation. Note: If the propeller is deformed or damaged, Altitude Hold Mode will fail. If the atmospheric pressure is instability or Typhoon weather, Altitude Hold Mode can not work well. - Page 12 Attention ① Switching sequence. At first, turn on the power of the drone, then turn on the power of the transmitter. After the end, turn off the power of the drone first, and then turn off the power of the transmitter. ②...
-
Page 13: Troubleshooting
Troubleshooting Problem Problem cause Solution Low battery. Replace the controller battery. The controller The batteries are incorrectly. Install the batteries following the polarity indicators. Indicator light is off. The batteries are incorrectly Clean the dirt between the battery and the positioned. -
Page 14: Fcc Note
FCC Note This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Need help?
Do you have a question about the U64 and is the answer not in the manual?
Questions and answers