Advertisement

USER
MANUAL
U88S
Note
▲This product is suitable for users over 14 years old.
▲Stay away from the rotating propeller
▲Read the "important statement and safety guidelines"carefully.
Drone Battery Li-Po Battery Disposal & Recycling
Wasted Lithium-Polymer batteries must not be placed with household
trash. Please contact local environmental or waste agency or the
supplier of your model or your nearest Li-Po battery recycling center.
Our company's products are improving all the time, design and
specifications are subject to change without notice. All the information in
Important
this manual has been carefully checked to ensure accuracy, if any
Notice
printing errors, our company reserve the final interpretation right.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the U88S and is the answer not in the manual?

Questions and answers

Kenny
June 15, 2025

The lights on the remote won't go off. They just flash.

Summary of Contents for UDI R/C U88S

  • Page 1 USER MANUAL U88S Note ▲This product is suitable for users over 14 years old. ▲Stay away from the rotating propeller ▲Read the “important statement and safety guidelines”carefully. Drone Battery Li-Po Battery Disposal & Recycling Wasted Lithium-Polymer batteries must not be placed with household trash.
  • Page 2 Ready before take off Drone preparation Front Propeller A Propeller B Drone cover Left Right Power switch Battery back cover Propeller B Propeller A Rear Front light Front light Camera (Green) (Green) Landing gear Rear light Rear light (Red) (Red)
  • Page 3: Battery Charging

    Battery charging Battery power is low in the original factory, It must be fully charged before use. Connect the original charging cable with the drone battery, and then connect other USB charging port. The charger line indicator is red when charging and the light turns green when fully charged.
  • Page 4: Transmitter Charging

    Transmitter Phone Holder Video Gimbal adjustment Photo Left stick Trimmer Indicator light Right Stick (press down) Power switch Return GPS switch Speed switch Follow Mode Encircle Mode Transmitter charging Battery power is low in the original factory, It must be fully charged before use. Connect the transmitter with the charging line of the original plant, and then connect other USB charging outlets.
  • Page 5: Installation

    The installation methods of mobile phone holder Installation ② Put the phone clip ① on the back of the Straightening the antenna quasi-remote controller and push it to the end. Disassemble ② Pull up the clip on the mobile phone ①...
  • Page 6: Flight Operations

    Flight Operations Mobile phone connect with Drone Download and install APP: UDIGPS This software is suitable for mobile phones in the IOS 9.0 or later and Android 4.4 or later system. For detailed operation, please check the system “HELP” of APP. Transmitter connect with Drone Frequency Pairing ②...
  • Page 7: Compass Calibration

    Compass calibration Rotate the drone horizontally until the transmitter sound "di..." Level correction to complete. When the front navigation light turns to long light and the rear navigation light flashes, enter vertical correction. rotate the vehicle vertically until the transmitter sound "di...", vertical correction over.
  • Page 8: Left Stick

    Unlocking the drone Push the left and right stick inward to the 45° angle simultaneously. ① On standby drone, motor rotation, drone Unlocked. ② When the drone is not take off, the motor stops rotating and the drone is locked. The drone can only take off when the motor is unlocked.
  • Page 9 Return During the flight, press the " " button, and the transmitter will sound "di", and the drone will automatically return to the take-off point. (during returning, the transmitter will continuously sound "di". To stop homing, just press this button again.) Notice: While returning, the control lever of the transmitter can not control the drone, it must be waited for the drone to go back to the take-off point.
  • Page 10: Gimbal Adjustment

    Encircling flight In flight, press the " " button, and the transmitter will make the sound of "di". Then it goes to the function of encircling flight. The drone will fly to a default radius then it waits for the direction controlled by the user. Adjust the speed and direction of the drone by manipulating the right stick.
  • Page 11: Low Battery Alarm

    Photo Video Press the " " button once to Press the " " button, the take a picture and the transmitter will sound "didi" transmitter will to start recording. sound "di". Repeat this action to stop recording and save the video. Notes for Filming ①...
  • Page 12 Out of Range Alarm When the drone is out of the remote control distance, the transmitter will continues to sound "didi...didi...didi..." to alarm the user to return the drone immediately. Stuck Protection 1. When the propellers get stuck ,then the drone LED will flash quickly and activate stuck protection function and the motors stop running.
  • Page 13: Parts Replacement

    Parts Replacement...
  • Page 14 Attention ① Switching sequence. At first, turn on the power of the transmitter, then turn on the power of the drone. After the end, turn off the power of the drone first, and then turn off the power of the transmitter. ②...
  • Page 15: Troubleshooting

    Troubleshooting...
  • Page 16: Fcc Note

    Los niños menores de 14 años deben ser supervisados por adultos. 警告: この製品は、 大人と14歳以上の子供には使用対象です。  14歳未満の子供は大人の監視が必要です。 Manufacturer company: SHANTOU CITY CHENGHAI UDIRC TOYS CO., LTD Manufacture address: Guangfeng Industrial Zone, Guangyi Street, Chenghai District, Shantou City, Guangdong Province, China Model: U88S Manufacture time: MADE IN CHINA...

Table of Contents