Nortel Meridian 1 Manual page 47

4 Unsnap the footstand assembly by pressing inward at the back of the
footstand where it meets the base, and pulling upward.
5 Rotate the footstand 180 degrees and screw the footstand back into
place to the set's bottom cover.
6 Tighten all screws and replace all cords.
7 Mount the telephone on the wall using the wall-mount holes provided
on the bottom of the footstand.
M2616CT configuration
To configure the M2616CT set refer to Software Input/Output Guide
Administration (553-3001-311) for complete information and procedures on
LD11 to configure the Meridian Digital Telephone. For the Locator key (key
14) to function, do not assign a feature to this key. Handsfree is required for
the M2616CT to function properly.
M2616CT Handset Registration to Base Unit
Each M2616CT handset is automatically registered to its respective base unit.
In cases where a substitute handset is required for troubleshooting purposes,
a different M2616CT handset can be reregistered by placing the handset
on-hook, and unplugging, then re-plugging in the ac power adapter and
telephone line cord.
M2616CT Manual RF (Radio Frequency selection
The M2616CT uses 900 MHz narrowband signaling. Other products also use
these channels. Due to interference from other products, there may be a time
when the installer must confirm the user's M2616CT so that other 900 MHz
products will not cause interference. The Manual RF Selection feature is a
function available on Key 14 in addition to the Locator feature. Procedure 2
describes the steps to follow to implement the Manual RF Selection feature:
Procedure 2
M2616CT Manual RF (Radio Frequency selection)
1 Add a feature (any feature) on the system's Key 14.
2 Press Key 14 and AUTO appears on the display.
3 Toggle the volume key until the desired channel (CH00 through CH19)
is reached. See Table 9.
Telephones
Telephone and Attendant Console Installation
Page 43 of 144