Other Symbols In This Documentation; Units Of Measurement; Safety; Intended Use - STIEBEL ELTRON SBP 1000 E Operation And Installation

OPERatIOn

Safety

1.2

other symbols in this documentation

Note
General information is identified by the symbol shown
on the left.
f Read these texts carefully. f
Symbol Meaning
Material losses
!
(appliance, consequential, environment)
Appliance disposal
f This symbol indicates that you have to do something. The ac- f
tion you need to take is described step by step.
1.3

units of measurement

Note
All measurements are given in mm unless stated oth-
erwise.
2. safety
2.1

intended use

This appliance is generally intended to be used for the storage,
heating and cooling of process water.
SBP E cool appliances are also permitted to store cooled process
water down to + 7 °C.
A glycol/water mixture of up to 60 % is permitted if only dezinci-
fication-resistant metals, glycol-resistant gaskets and diaphragm
expansion vessels suitable for glycol are used throughout the in-
stallation.
Any other or additional use is inappropriate, in particular usage
with alternative storage media. Observation of these instructions
and of instructions for any accessories used is also part of the
correct use of this appliance.
2.2

general safety instructions

WARNING Burns
There is a risk of scalding at outlet temperatures in ex-
cess of 43 °C.
WARNING Injury
!
Where children or persons with limited physical, sensory
or mental abilities are allowed to control this appliance,
ensure that this will only happen under supervision or
after appropriate instruction by a person responsible
for their safety.
Children should be supervised to ensure that they never
play with the appliance!
www.stiebel-eltron.com
3.

appliance description

This appliance is designed to extend the operating time of the
heat source and to bridge power-OFF periods. It is also designed
for the hydraulic separation of the volume flow between the
heat/refrigerant source circuit and the heating/cooling circuit.
Suitable heat exchangers, flanged and threaded immersion heat-
ers can be fitted by contractors. In addition, up to two further heat
sources (e.g. a solid fuel boiler) can be connected. The appliance
is equipped for fitting five sensor wells. A sleeve enables a ther-
mometer to be fitted.
sBP e sol
SBP E SOL buffer cylinders are additionally equipped with a
smooth tube indirect coil for heating the cylinder content with
solar energy.
sBP e cool
SBP E cool buffer cylinders are equipped with a vapour diffusion-
proof preinsulation to protect against the formation of condensate.
This must be combined with thermal insulation WD cool.
4.

cleaning, care and maintenance

f Have a contractor regularly check the appliance, the safety f
assembly and all fitted accessories.
f Never use abrasive or corrosive cleaning agents. A damp f
cloth is sufficient for cleaning all plastic parts.
scaling
f Almost every type of water deposits limescale at high tem- f
peratures. This settles inside the appliance and affects both
the performance and service life. The indirect coils and fitted
accessories should therefore be descaled from time to time.
A heating contractor who knows the local water quality will
tell you when the next service is due.
f Check the taps/valves regularly. You can remove limescale f
deposits at the tap outlets using commercially available des-
caling agents.
5.

troubleshooting

Telephone your contractor. To facilitate and speed up your enquiry,
please provide the serial number from the type plate (000000-
0000-000000):
SBP 1000-1500 E | E SOL | E cool |
000000-0000-000000
Made in Germany
15