Operating Instructions And Parts Manual
Replacement Parts List
•
Only use factory parts to repair
this pump.
Specifications
Power supply requirements......120V, 60 hz
Motor .........................................Single phase, oil filled
Horsepower................................1/3 HP (CDT33, SPT33, SSPT33)
....................................................1/2 HP (CDT50, SPT50, SSPT50)
Liquid temperature range ........40°F to 120°F
Circuit requirements..................15 amps (min)
Dimensions.................................11
Cut-in level (factory set)............13"
Cut-out level (factory set) .........7"
For Replacement Parts, call 1-800-237-0987
Please provide following information:
-Model number
-Serial number (if any)
-Part description and number as shown in parts list
Ref.
No.
Description
1.
Tether Float Switch Kit
2.
Top Cover Kit
3.
Impeller Plate
4.
Impeller
5.
Volute
1
/
" high x 9
3
/
" base
2
4
3
60022-001
60030-001
60000-001
60016-001
Construction
Motor housing .................Cold rolled steel
Volute ...............................Cast iron (CDT33, CDT50)
..........................................Glass Reinforced Thermoplastic
(SPT33, SPT50, SSPT33, SSPT50)
Impeller ............................Glass reinforced thermoplastic
Shaft .................................Low carbon steel
Seals ..................................Buna N
Discharge..........................1
Motor Cover .....................Glass reinforced thermoplastic
Address parts correspondence to:
Wayne Water Systems
101 Production Drive
Harrison, OH 45030
Part Numbers for Models
CDT33
SPT33, SPT50
CDT50
SSPT33, SSPT50
60022-001
60030-001
15958
15958
60000-001
60007-001
1
/
" NPT
2
www.waynewatersystems.com