General; Application; System Description - Kessel Aqualift F Installation, Operation And Maintenance Instructions

Wastewater station for floor-slab installation for wastewater with or without sewage
Table of Contents

Advertisement

Available languages

Available languages

1.1 Application

This system is designed for pumping waste-
water with or without raw sewage. Impor-
tant is that sufficient water is always availa-
ble - pressing the 'water savings' flush on
toilets is not recommended.
Important!
The KESSEL Aqualift F Wastewater
Station is not for use with flammable or ex-
plosive liquids. The system should only be
used for the macerating of sewage, toilet
paper and gray water. The warranty of this
product does not include damage to the sy-
stem caused by the pump intaking banda-
ges, tampons, cotton swabs, razor blades,
moist towels, cotton, hair, sponges, plastic
bags, washclothes, diapers or other objec-
ts. The pumping of solvents and thinners is
also not allowed. It is recommended that the
warning sticker shown below is placed in the
proper visible area to prevent improper

1. General

items entering the drainage system. Con-
densation fluids from furnaces / heaters
should be neutralized or adequately diluted
with water.

1.2 System Description

The KESSEL Aqualift F Wastewater Station
is a lifting station with an unmatched power
to size ratio. Through the use of high end,
permanently resistant plastics, the system is
able to handle household acids and bases
(ph value from 6.5 to 10) as well as cold and
hot water (up to 95 deg C for short periods).
The lifting station consists of a pump with
non-return flap, quick release flange
connection, vertically adjustable upper sec-
tion and a 300 kg rated tileable cover with an
integrated odour free floor drain. For deeper
installations in floor slabs, the extension
section (Article Number 83071) should be
used. KESSEL recommends the connection
of a closure valve to the outlet pressure pipe
of the system.
The Aqualift F Wastewater Station is avail-
able in three models:
- single pump with float switch
(Article Number 28300)
- single pump with SDS control unit
(Article Number 28350)
- twin pumps with SDS control unit
(Article Number 28330)
6

Advertisement

Table of Contents
loading

Table of Contents