Black & Decker Performance FusionBlade Use & Care Manual page 6

8. When finished press
blending. Make sure blades have completely
stopped before attempting to remove
the blending jar from the base. (Refer to
troubleshooting for any issues).
9. Press (on/off) to power off (E). Unit will auto
shutoff after 60 seconds without use.
10. To remove the jar, grasp the handle and lift up.
11. Remove lid to pour.
12. Always unplug the appliance when not in use.
USING THE PERSONAL BLENDER JAR
Note: Do not blend hot liquids in the personal jar.
1. Place the personal blender jar on a flat surface with the open end facing
up. Fill the jar with ingredients. Do not fill ingredients past the "20oz."
marking.
2. Tighten the personal jar blade assembly on the open end of the personal
jar with the blade facing down towards the ingredients. It is important to
tighten to prevent leaking during blending.
3. Turn personal jar upside down and place on the blender base, turning
clockwise to lock into place.
4. Select the appropriate speed or use
desired consistency.
IMPORTANT: It is recommended to only use speeds 1-3 or auto 3 when
using the personal jar.
5. Once blending has finished, remove the personal jar by turning
counterclockwise and lifting off the base. Turn the jar over and place it
on a flat surface.
IMPORTANT: If the jar gets stuck on the blending base or begins to loosen
from the blade assembly, follow these steps:
a. Unplug the unit
b. Turn the jar clockwise to tighten jar onto the blade assembly
c. Turn jar and blade assembly counterclockwise to unlock
from blending base and lift up.
(pulse/stop) to stop
(pulse/stop) to blend to
6