Assembly; General Assembly - pronovost P-INV-74 Operator's & Parts Manual

ASSEMBLY

4
Figure 17
ASSEMBLY
1) The Snowblower is shipped partly assembled.
2) Install 3-point system according to the model of
your Snowblower. (See section 10 for parts
numbers). Use the holes most convenient to the
type of tractor used (Fig. 17).
3) Install P.T.O. shaft with the shear pin end onto the
Snowblower gear box. Then attach safety shield
support chain as shown. WARNING: The
telescoping tubes of the drive shaft must never be
allowed to bottom out while maintaining a mini-
mum overlap of 6 inches.
4) If you install a hydraulic cylinder on the chute
deflector, use model 25TR04 cylinder.
5) When installing chute, grease the groove of the
UHMW slide in order to prevent the corrosion of
the rim of the chute.
6) For the installation of the chute rotation
mechanism, please refer to parts section,
according to the type used.
- 12 -