Assembly; General Assembly - pronovost P-540 Operator And Parts Manual

ASSEMBLY

4
Figure 18
Figure 19
Figure 20
ASSEMBLY
1) The Snowblower is shipped partly assembled.
2) Install 3-point system according to the model of
your Snowblower. (See section 10 for parts
numbers). Use the holes most convenient to the
type of tractor used (Fig. 18).
3) Install P.T.O. shaft with the shear pin end onto the
Snowblower gear box (Fig. 19). Then attach
safety shield support chain as shown (Fig. 20).
WARNING: The telescoping tubes of the drive
shaft must never be allowed to bottom out while
maintaining a minimum overlap of 6 inches.
4) If you install a hydraulic cylinder on the chute
deflector, use model 25TR04 cylinder.
5) For the installation of the chute rotation
mechanism, please refer to page 28 through 29,
according to the type used.
- 12 -