Assembly; General Assembly - pronovost P-860IV Operator And Parts Manual

Inverted snowblower
Table of Contents

Advertisement

ASSEMBLY

Figure 16
ASSEMBLY
1) The Snowblower is shipped partly assembled.
2) Install 3-point system according to the model of
your Snowblower. (See section 10 for parts
numbers). Use the holes most convenient to the
type of tractor used (Fig. 16).
3) Install P.T.O. shaft onto the snowblower rotor.
You must put the shear pin end to the tractor PTO
output shaft and the other end on the snowblower
rotor shaft. Then attach safety shield support
chain as shown. WARNING: The telescoping
tubes of the drive shaft must never be allowed to
bottom out while maintaining a minimum overlap
of 6 inches.
4) If you install a hydraulic cylinder on the chute
deflector, use model 25TR08 cylinder.
5) When installing chute, grease the groove of the
UHMW slide in order to prevent the corrosion of
the rim of the chute.
6) Install the chute rotation mechanism.
- 12 -

Advertisement

Table of Contents
loading

This manual is also suitable for:

P-920iv

Table of Contents