Control Functions - Magnum Rc Control Center - Magnum Original Series Use And Installation Manual

Use and installation manual for a MAGNUM sauna stove

1.2 Control functions - Magnum RC Control Center

Legend for the parts of the control panel:
1. On/off button.
set, pressing this button starts the timer for heating the sauna. Tip: Pressing this button for a
longer duration overrides the timer and starts the heating of the sauna immediately.
Menu button. By pressing this you can move through the menus of the device as follows:
2.
(Default mode –> Target temperature –> Heating time –> Timer –> Default mode)
(–) button. This button is used to decrease the default values.
3.
(+) button. This button is used to increase the default values.
4.
Lights button. By pressing this, you can turn on the sauna stove's light. Pressing it again turns
5.
the light off. (Used only in models with lights)
Timer light. Light is on: heating time setting / timer setting mode (or the default mode, if the
6.
display shows the remaining time).
Target temperature setting indicator light. When this light is on, it is possible to change the
7.
target temperature.
"Device on" light. This light is constantly on when the sauna stove is on.
8.
The light "glows" when the timer is in use. The light is turned off when the sauna stove is not
on.
Three-digit display
9.
Starsauna Oy
Pistotie 4
15860 Hollola, Finland
Pressing this button turns the sauna stove on and off. If the timer has been
16.06.2015 5
Sauna stove On/Off
Menu
Decrease
Increase
Lights button
The signal light of heating/timing
Signal light of the stove light
Signal light of the menu settings
Number display
Technical support:
info@magnumkiuas.fi