Installing The Control Centers In The Sauna Room - Magnum Original Series Use And Installation Manual

Sauna stove with finlandia and magnum rc control centers
Table of Contents

Advertisement

Use and installation manual for a MAGNUM sauna stove
3.4

Installing the control centers in the Sauna room

Finlandia
1. Check the central unit's height and distance in the installation manual. Chapter 4.1
2. Use a box drill to drill a 70 mm hole in the panel for the box. Be careful not to drill all the
way to the insulation! If you penetrate the insulation plate/foil, repair it with aluminum tape.
3. Install the bottom of the box to the hole. Fasten it with fasteners that come with the bottom.
4. Draw the wires from the sauna stove to the hole along the lower edge of the panel, for
example, and pull them out of the box.
5. Install the central unit's bracket in the box.
6. Connect the wires. See Chapter 3.3
7. Press the central unit into the bracket and attach it with two plastic tacks.
8. Install the controller to the sauna stove as set in Chapter 3.3.
NOTE! The electric grid connection process may only be performed by a licensed electrician.
The bottom of the box is not delivered with the sauna stove. One suitable
box is the ABB mounting box for board walls AUS-15.2p. These boxes are
sold in all well-equipped hardware stores.
1.
2.
3.
4.
Do NOT cut the wire from the side of the controller. The controller does
not function if the wires are extended/reconnected. If the wire needs to be
shortened, shorten it from the connector's side. In other cases, contact the
technical support.
Starsauna Oy
Pistotie 4
15860 Hollola, Finland
Magnum RC
Install the screws in the panel using the template supplied with the
panel. Leave the screws approximately 2 mm out of the wooden
surface. Cut the template from the side 9.
If you want the wire to go through the panel, drill a hole in the
template part. Diameter of the hole must be at least 8 mm.
After screwing in the screws and drilling the hole, take the wire of
the controller through the hole and install the controller on the
screws. Finally, remove the protective liner from the controller.
Connect the controller to the sauna stove as provided in Chapter
3.3.
16.06.2015 15
Technical support:
info@magnumkiuas.fi

Advertisement

Table of Contents
loading

Table of Contents