Installation - Magnum Original Series Use And Installation Manual

Use and installation manual for a MAGNUM sauna stove
Section III.1
1.
2.
3.
4.
5.
Starsauna Oy
Pistotie 4
15860 Hollola, Finland

Installation:

Remove the stainless steel frame from the upper part of the sauna stove.
Remove the protective plastics.
Set the sauna stove's lower part in the location you have chosen for the stove in a
way that ensures that the maintenance/installation hatch at the foot of the sauna
stove faces an open space. In the Lite / Cenik model, turn the sauna stove on its
side, against a clean platform. Make sure the sauna stove is not scratched.
Open the hatch at the base of the sauna stove and connect the feeder line to the
sections of the bayonet joint. L1, L2, L3, N, Ground, Ground (see image)
Temperature reduction (Connector J5) (If this feature is in use, it is possible to
connect a relay or contactor coil to the output, which control the heating of the
building) Detach the connector from the circuit card and screw the cables to the
connector. Then, press the connector back onto the circuit card. The screws will
point right when pressing the connector.
N - 230VAC OUT - Blue above
P - External - Brown below.
16.06.2015 11
Technical support:
info@magnumkiuas.fi