Installing The Thermostat Sensor - Magnum Original Series Use And Installation Manual

Sauna stove with finlandia and magnum rc control centers

Hide thumbs

Table Of Contents

Table of Contents

Use and installation manual for a MAGNUM sauna stove

Section III.2

Heat sensor

Connecting the sensor wire from the left LIYY CABLE (gray):

connector

To circuit

card

Connection of the sensor wire, from the left SILICONE

CABLE (light brown, right on the picture):

connector

To circuit

card

All Magnum sauna stoves bought from 1 October 2015 onwards have been equipped

with the new silicone cable.

Connect the connector to the circuit card's connector and press it carefully all the

way down.

When installing the thermostat sensor on the wall, the distance from the roof to the

upper edge of the sensor should be 100 mm. The sensor must be located 500-1000

mm from the upper edge of the sauna stove.

Furthermore, the sensor must be located at least 1000 mm from a non-directed incoming

air valve or 500 mm from an incoming air valve which is located away from the device.

See the image at page 16.

Install the thermostat cable behind the panel in the air

vent. If this is not possible, use an installation baseboard.

Make sure that the incoming air does not disturb the heat

sensor.

Do NOT cut the wire from the thermostat's side. The

thermostat sensor does not function if the wires are

continued/reconnected. If the wire needs to be shortened,

shorten it from the connector's side. In other cases,

contact the technical support.

Starsauna Oy

Pistotie 4

15860 Hollola, Finland