Trane CenTraVac Duplex CDHF Operation & Maintenance Manual page 45

System Mode Overrides
Description
1. Compressor
Control Signal
2. Evap Water Pump
3. Cond Water Pump
Circuit Mode Overrides
Description
1. Oil Pump
2. Clear Restart Inhibit Timer
3. Purge Exhaust Circuit Test
4. Purge Regen Cycle
5. Front Panel Ckt Lockout
Purge
Description
1. Purge Operating Mode
2. Daily Pumpout Limit
3. Disable Daily Pumpout Limit
(0 to disable)
4. Purge Liquid Temp Inhibit
5. Purge Liquid Temp Limit
Display Settings
Description
1. Date Format
2. Date
3. Time Format
4. Time of Day
5. Keypad/Display Lockout
6. Display Units
7. Pressure Units
8. Language
(1) Temperatures will be adjustable to 0.1 degree F or C. The Main Processor provides the minimum and maximum allowable value.
(2) Adjustable to the nearest whole number percent. The Main Processor provides the minimum and maximum allowable value.
(3) Terminates with 10 minutes if inactivity
(4) The Date and Time setup screen formats deviate slightly from the standard screens defined above. See the time and date section for further details.
™
(5) Enables a DynaView Lockout screen. All other screens timeout in 30 minutes to this screen when enabled. The DynaView
permit the user to exit the lockout with a fixed password (1-5-9 + Enter). See lockout setion for further details.
(6) Language choices are dependent on what has been setup in the Main Processor. Language selections will include English and qty 2 alternate as loaded by TechView
Language shall always be the last setting listed on the Display Settings menu. This will allow a user to find language selection if looking at an unrecognizable language.
(7) Manual Compressor Control allows an operator to override the Auto Control and manually control the compressor while in operation. This is not active during Stop
mode.
CDHF-SVU01C-EN
Operator
Interface
Resolution or (Enumerations), Default
XXX / (Auto,Manual [0-100] ), Auto
(Auto, On), Auto
(Auto, On), Auto
Resolution or (Enumerations), Default
(Auto, On), Auto
(Off, On), Off
(Off, On), Off
(Not Locked Out, Locked Out), Not Locked Out
Resolution or (Enumerations), Default
(Auto, On, Adaptive, Stop), Adaptive
XXX
0, XX
(Enable, Disable), Enable
XXX.X
Resolution or (Enumerations), Default
("mmm dd, yyy", "dd-mmm-yyyy"), "mmm dd, yyy"
(12-hour, 24-hour), 12-hour
(Enable, Disable), Disable
(SI, English), English
(Gauge, Absolute), Absolute
(English, Selection 2, Selection 3), English (2)
Units Monitor Value
Enum IGV % Open
Evap. LWT
AFD Freq.
Enum 1) Evap Flow
status
2) Override Tim
e Remaining
Enum 1) Cond Flow
status
2) Override Time
Remaining
Units Monitor Value
Enum 1) Diff press
2) Override Time
Remaining
Enum none
Enum Carbon Temp
Enum
Units
Enum
Minutes
Hours
Enum
Temperature
Units
Enum
Enum
Enum
Enum
Enum
Enum
™
Lockout Screen displays a 0-9 keypad to
™ .
45