Trane CenTraVac Duplex CDHF Operation & Maintenance Manual page 41

Report name: System Evaporator
Description
1. Evap Entering Water Temp
2. Evap Leaving Water Temp
3. Evap Water Flow Switch Status
4. Evap Differential Wtr Press
5. Approx Evap Water Flow
6. Approx Chiller Capacity
Report name: Circuit Evaporator
Description
1. Evap Sat Rfgt Temp
2. Evap Rfgt Pressure
3. Evap Approach Temp
Report name: System Condenser
Description
1. Cond Entering Water Temp
2. Cond Leaving Water Temp
3. Cond Water Flow Switch Status
4. Cond Differential Wtr Press
5. Approx Cond Water Flow
6. Outdoor Air Temperature
Report name: Circuit Condenser
Description
1. Cond Sat Rfgt Temp
2. Cond Rfgt Pressure
3. Cond Approach Temp
Note: Approach temperatures shown are the mathematical difference between the chiller leaving water temperature and
the corresponding saturated refrigerant temperature of same circuit. When one compressor is operational the approach
value will be similar to those values found on single compressor models. However when both compressors are
operating, the upstream compressor circuits approach will be the mathematical difference of the upstream chillers
refrigerant temperature and the leaving water temperature after the down stream chillers circuit. Therefore the approach
of the upstream circuit will be a negative number in many instances, when both compressors are operating.
CDHF-SVU01C-EN
Operator
Interface
Resolution
+ or – XXX.X
+ or – XXX.X
(Flow, No Flow)
XXX.X
XXXX
XXXX
Resolution
+ or – XXX.X
XXX.X
+ or – XXX.X
Resolution
+ or – XXX.X
+ or – XXX.X
(Flow, No Flow)
XXX.X
XXXX
+ or – XXX.X
Resolution
+ or – XXX.X
XXX.X
+ or – XXX.X
Units
Temperature
Temperature
Diff Pressure
Flow
Tons
Units
Temperature
Pressure
Temperature
Units
Temperature
Temperature
Diff Pressure
Flow
Temperature
Units
Temperature
Pressure
Temperature
Dependencies
If option installed
If option installed
If option installed
Dependencies
Dependencies
If option installed
If option installed
If option installed
Dependencies
41