Simple Counting - Jadever JWI-700D Series Manual

rightwards; Press
M-/SET
3. Press
M+/SAVE
4. Press
Place the sample on the weighing pan, if the sample weight is under the lower weight range while over
20d, the LOW lamp will light up. If the sample is within the lower and upper weight range the OK lamp
will light up. If the sample is over the upper weight range, the HI lamp will light up.

7-4 Simple Counting

UNIT
1. Press key
G/N,
2. Press key
+/PRINT/HI
3. Use key
are10、20、50、100、200、500( pieces)
4. Put the corresponding samples on the weighing pan, and then press key
is displayed momentarily before the display reverts to the sample quantity.
5. Remove the samples and put the load on, the scale calculates the amount of the load.
6. To go back to the normal weighing mode, remove the load and press key
proper weighing unit.
Note:
1. The larger the sample size, the more accurate unit weight.
2. Symbol " " points at "UW" when calculated unit weight is lower than 4 / 5 of scale division.
+/PRINT/HI
or
to enable / disable the check weighing function
to save the Lower limit and return to weighing mode
to select the unit "PCS".
the ex-factory default sample quantity (10 pcs) is displayed.
-/ OLD/
H
or
→
-/ OLD/
H LO
to change the value
LO
to choose the sampling amount. Available options
.
JWI-700D/700S
TARE
. "
UNIT
to select the
14
"