Calibration - Jadever JWI-700D Series Manual

always： Tare/Zero function acts by pressing down key
stable
12. Power saving function
on: Enable the power saving function
off: Disable the power saving function
13. Initialization
M-/SET,
Press
the initialization is finished

6. Calibration

Note: Before calibration, please set the unit first. The unit used in calibration is the one that has
been set before. During the calibration procedure, press
weighing mode without saving.
Here we take 3kg/10g as an example
1. Press and hold
2. With no load on the weighing pan, press
blanking at the left bottom.
3. Wait till the window displays the first calibration value. "
Note: The first calibration value is default. If you need to change the value, do as the following:
M-/SET
Press
or rightwards. Press
save.
4. Put the corresponding weight on the weighing pan, and then press
first point calibration. "
Note: After the first point calibration, the window can display the weight value. If no need for
the other point calibration, move to step 6 to finish the calibration procedure.
5. Add another mass to the current weight. The window will show the total weight. Press
M+/SAVE
then press
while powering on. Do not release it till the window displays "CAL".
TARE
to enter the value setting. Press
+/PRINT/HI
"appears at the left bottom.
to start initialization. After the window displays "ok",
TARE
to start zero point calibration.
MR/
-/ OLD/
H LO
or
to change the value. Press
JWI-700D/700S
TARE ZERO
or
ZERO/ESC
to return to normal
"appears at the left bottom.
TARE/
or
to move the key leftwards
TARE
even if it is not
"is
"
M+/SAVE
to
to complete the
TARE
11