Installing The Lsqm1Wcmb0 Module - H3C LSQM1WCMB0 Installation Manual

Installing the LSQM1WCMB0 module

Face the front side of the switch.
1.
Choose an empty slot and remove the blank filler panel.
2.
Push the access controller module into slot along the guide rails until the positioning
3.
hole of the board is seated onto the positioning pin on the backplane.
Pivot the ejector levers toward the front panel to lock the access controller module
4.
in place.
Using a Philips screwdriver, fasten the captive screws on the access controller
5.
module.
If the switch is powered off, power on the switch.
6.
16