Cleaning The Treadmill - Precor M9.3s Owner's Manual

5
Photo 8
Frame
Running belt
Margins of running bed
page 26
Maintaining the M9.3s Treadmill
The M9.3s treadmill requires little maintenance to keep it running smoothly and
efficiently. Typical maintenance tasks include cleaning the treadmill and
adjusting the running belt. Instructions for both procedures are provided in this
section.
Cleaning the M9.3s Low Impact Treadmill
Your Precor precision treadmill relies on low friction for efficient operation. To
keep the friction low, the treadmill must be as clean as possible. Photo 8
illustrates the locations that should be kept clean.
CAUTION: Turn OFF the treadmill and unplug the power cord before
cleaning.
Before a workout, use a damp, soft cloth to clean the staging platforms, running
bed, and under the belt as far as you can easily reach. This removes any dirt or
dust that might affect the smooth operation of the treadmill.
Keep these areas
on the M9.3s
treadmill clean.
Vacuum underneath the unit every week to prevent the accumulation of dust
and dirt on the running belt.
Periodically, clean the treadmill's frame, electronic console, and running belt
using mild soap and water. To clean the running belt, use a soft nylon scrub
brush. Do not pour water or spray liquids on the control panel. Allow the
treadmill to dry completely before using.