Precor M9.3s Owner's Manual page 8

Photo 1
Running Bed Assembly
Ribbon Cable
Control Panel Assembly
Foam blocks
Photo 2
Frame rail
Mounting Bolts
Keyholes
page 8
Connect ribbon
cable.
5. To place the control panel assembly onto the front of the running bed, take
the following steps. Refer to Photo 2 for clarification.
a. Locate the four mounting bolts on the running bed assembly. Use the
hex key provided to unscrew the mounting bolts until four or five
threads are visible.
b. Position the control panel assembly in front of the running bed assem-
bly. Line up the four mounting bolts on the running bed with the four
keyholes in the control panel assembly. Place the control panel assem-
bly onto the mounting bolts, making sure to feed the excess ribbon
cable into the frame rail to avoid pinching the ribbon. (See Photo 2.)
Place control panel
assembly onto
mounting bolts.
6. Slide the control panel assembly upward to lock the mounting bolts in
place. Tighten the top two bolts using the 5/16" hex key from the hardware
kit. (See Photo 3.)