Westin 45-3550 Instructions

AUTOMOTIVE PRODUCTS, INC.
ITEM QUAN-
TITY
1 1
2,3 2
4 4
5 8
6 4
7 8
8 16
9 8
10 8
1. Remove contents from box, verify all parts listed are present and free from damage. Carefully read and understand all instructions before
attempting installation.
2. Starting on the driver side, remove the (4) factory hex bolts and nuts, (Figure 1 & 2), securing the tow hook to the frame. It may be neces-
sary to use a long extension to reach between the frame and the radiator to remove the inner factory hex nuts, (Figure 2). Place the hard-
ware and tow hook aside. Insert the driver side Frame Mounting Bracket through the opening in the bumper and up to the mounting sur-
face, (Figure 3 & 4). Use the supplied longer (4) M10 hex head bolts, (8) M10 flat washers, (4) M10 lock washers, and (4) M10 hex nuts.
Do not fully tighten at this time. Repeat this step for the Passenger Side Mounting Bracket.
3. Lift the grille guard into place outside the previously installed mounting brackets, attach to the brackets using (4) M12 hex head bolts, (8)
M12 flat washers, and (4) M12 nylock nuts. Do not fully tighten at this time
4. Check for clearance between the hood and make any necessary adjustment then tighten all hardware at this time.
5. Torque all M12 hardware to 35-40 ft lbs, M10 to 25-30 ft lbs
Westin Automotive Products, Inc.
5200 N. Irwindale Ave. Ste 220
Irwindale, Ca 91706
INSTRUCTIONS—INSTRUCCIONES—CONSIGNES
MOUNTING BRACKETS (2) DRIVERS SIDE, (3) PASSENGER SIDE
M12 X 35MM HEX HEAD BOLTS
M12 FLAT WASHERS
M12 NYLOCK NUTS
M10 X 45MM HEX HEAD BOLT
M10 FLAT WASHERS
M10 LOCK WASHERS
APPLICATION: DODGE RAM 2500/3500 2010-UP
PART 45-3550, 40-3555
DESCRIPTION
GRILLE GUARD
M10 HEX NUTS
TOOLS NEEDED
18MM SOCKET AND
RATCHET
16MM SOCKET AND
RATCHET
TORQUE WRENCH
Thank You for choosing Westin products
For additional installation assistance please call
Customer Service (800)793-7846