Lan Search; Real Time Lan Search - Encom Harmony IP I/O8 User Manual

Harmony IP I/O8 Network Monitoring & Control User Manual

LAN SEARCH

,
To program a Harmony IP radio it must first be 'discovered' by ControlPAK. This means the radio must be physically
connected to your Ethernet network, or connected directly to the computer on which you are running ControlPAK. The Real
Time Network Scan list results screen (shown above) is the root menu which displays the 'discovered' radios in the network
and allows the selection of, and access to, a specific radio for programming. When programming of that radio is complete
you are returned to the Real Time Network Scan list screen, where you can continue selecting and configuring each of your
and repeating the configuration steps
radios .

REAL TIME LAN SEARCH

If you do not see your radio listed, click the Refresh button to update the list. When you program a radio as outlined in the
following pages, the radio will be reset, and the software will return to this page. At that point the radio will still be
completing its reboot process and will not be shown on this screen. Wait about 1 minute then click Refresh and the complete
list will be shown. You can also select another radio and go through its configuration process while other radios are
rebooting.
Click the Auto Refresh check box to have the ControlPAK™ software automatically refresh the LAN search. The interval for
running the Auto Refresh can be set as desired.
11