Lan Search; Real Time Lan Search - Encom Harmony Series User Manual

Harmony Gateway Basic User Manual

LAN SEARCH

To program a Gateway Basic radio, it must first be 'discovered' by ControlPAK. This means the Gateway Basic
must be physically connected to your Ethernet network, or connected directly to the computer on which you
are running ControlPAK. The Real Time Network Scan list results screen (shown above) is the root menu which
displays the 'discovered' radios in the network and allows the selection of, and access to, a specific radio for
programming. When programming of that radio is complete, you are returned to the Real Time Network Scan
list screen, where you can continue selecting and configuring each of your radios and repeating the configuration
steps.

REAL TIME LAN SEARCH

If you do not see your radio listed, click the Refresh button to update the list. When you program a radio as
outlined in the following pages, the radio will be reset, and the software will return to this page. At that point,
the radio will still be completing its reboot process and will not be shown on this screen. Wait about one minute,
then click Refresh and the complete list will be shown. You can also select another radio and go through its
configuration process while other radios are rebooting.
Click the Auto Refresh check box to have the ControlPAK™ software automatically refresh the LAN search. The
interval for running the Auto Refresh can be set as desired.
14