Power Switch; Indicator Light - Mix Out; Reset Button; Air Tube - Taylor 358 Operator's Manual

USER INTERFACE

Power Switch

The middle position is OFF. The left position is Wash,
which activates the beater motor only. The right position
is Auto, which activates the beater motor and the
refrigeration system.

Indicator Light - MIX OUT

The MIX OUT light is on the front of the machine. When
5
the MIX OUT light begins to flash, the mix hopper is
almost completely exhausted and has an insufficient
supply of mix to operate the freezer. Only a small amount
of mix (less than 1 pint) is left in the hopper.
At this time the Auto mode is locked out and the freezer
shuts down, protecting the freezer from damage due to a
freeze-up. To initiate the refrigeration system, add mix to
the mix hopper. The freezer will automatically begin
operation.
5-2
Figure 5-3
Figure 5-4

RESET Button

CAUTION! DO NOT use metal objects to press
the reset button. Failure to follow this instruction may
result in electrocution.
The RESET button is in the left-side panel on the Model
358. The RESET buttons are in the lower front panel on
the Model 359. The reset mechanism protects the beater
motor from overloading. Should an overload occur, the
reset mechanism will trip.
To properly reset the freezer, place the power switch in
the OFF position. Press the RESET button firmly. Place
the power switch in the Wash position and observe the
freezer's performance. Open the side access panel to
check if the beater motor is turning the driveshaft in a
clockwise (viewed from operator end) direction without
binding.
If it is turning properly, place the power switch in the Auto
position to resume normal operation. If the freezer shuts
down again, contact a Taylor service technician.

Air Tube

The air tube is designed with a hole on one end. After
priming the machine, install the air tube into the mix inlet
hole with the hole end down. Every time the draw handle
is raised, new mix and air from the hopper will flow down
into the freezing cylinder. This will keep the freezing
cylinder properly loaded and maintain overrun.
Models 358 and 359
Figure 5-5
User Interface