Clearaudio TT5 User Manual page 12

Hide thumbs Also See for TT5:

User manual / Bedienungsanleitung

For this, remove both screws from the TT5 VTA clamp with the enclosed hex wrench #3.

Place the two halves of the VTA clamp around the tonearm pillar so that they sit on the tonearm

base or swing base and gently tighten the screws with the hex wrench #3.

Now you can loosen the screw of the clamping ring / tonearm base, or the screws of the swing base,

and continue to point 5.5.

a = b

Pic. 16: Adjusting the VTA with the TT5 VTA fix

5.5 Adjustment of the azimuth

( vertical position of the cartridge / stylus in the record groove)

I mportant: Please use extreme caution during this step. Alw ays lift the arm upw ards

during the adjustment.

Using the arm lift lever, lower the cartridge carefully onto the included adjustment gauge. Now

check from the front and with the help of the Mini Level Gauge the alignment of the cartridge and

re-adjust it if necessary.

The cartridge is in perfect alignment when it is vertical to the surface of the platter (see Pic. 17)

and the bubble of the Mini Level Gauge is centered (Pic. 18).

Pic. 17: Perfect Azimuth

90°

Pic. 18: Adjustment of the azimuth

Table of Contents