JUKI APW-895N/IP-420 Basic Operation Manual page 33

When there is no material on the clamp foot, press CLAMP FOOT BACK button
foot moves to the back with the fl ap presser closed. At the same time, the confi rming screen is released
and the screen returns to the sewing screen.
When canceling clamp foot back, press CANCEL button
the clamp foot does not move to the back. At the same time, the confi rming screen is released and the
screen returns to the sewing screen.
When there is material on the clamp foot, be sure to press CANCEL button
the material.
Then depress back the pedal again to move the clamp foot to the back.
At this time, the error screen is displayed to inform that stop switch
is pressed. When RESET button
released and the screen returns to the input screen.
⑤ Depress back the pedal at the time of selection of the long
and wide type.
At the time of selection of
depressing back the pedal in the green sewing screen (screen B),
the confi rmation screen as shown on the left side is displayed.
When the clamp foot moves to the back by depressing back the
pedal, it retreats with the fl ap presser closed. This screen is to
confi rm whether material is put on the clamp foot.
Confi rming message saying that "Clamp foot moves to the back
with fl ap presser closed. Remove material on the clamp foot" is
displayed.
− 12 −
is pressed, the error is
the long and wide type, when
, and the fl ap presser is opened. Then
and the clamp
and remove