Advertisement
Terminating an Outdoor Network Cable with Shielded RJ45 Connectors
Prepare an outdoor network cable
Prepare the following tools.
and shielded RJ45 connectors.
RJ45 connector crimping tool
1.
Core wire
2.
Aluminum foil
3.
Braid shield
4.
Outer jacket
5.
Shielded RJ45 connector
Diagonal pliers
Insert the arranged core wires into an RJ45 connector according to the pin
assignments and crimp the connector with the crimping tool.
Crimp the RJ45
connector.
Pin assignments of an RJ45 connector
•Before crimping, ensure that the core wires are fully inserted in the RJ45
connector.
•Use the crimping tool to crimp the connector with force.
•After crimping, verify that the connector has been crimped tightly.
Optional: Use a multimeter to measure the impedance of core wires. The impedance
8
difference between core wires must be less than 5%.
10/11 >>
Strip the cable.
Length of the stripped
Remove the outer jacket.
cable: 20 mm
When stripping off the outer jacket, take care not to damage the braid shield
or aluminum foil.
Cut off the exposed braid shield and materials
along the edge of the connector.
Cut off the exposed braid
shield and materials.
Strip off the braid shield and cut
the aluminum foil and unwanted
materials.
Cut the core wires neatly.
Terminate a connector on the other end of the network cable, and then test the cable
for continuity using a network cable tester.
Outdoor network cable
In addition to Ethernet services, the P&E port of the RTN 310 receives PoE signals from power
sourcing equipment (PSE). An outdoor straight-through cable is used to connect the P&E port and
PSE.
The pin assignments of the P&E port on some Ethernet power supply equipment may be different
from those on the RTN 310. You need to make a network cable based on the pin assignments of the
two P&E ports.
Pin assignments of the P&E port on the RTN 310
Pin No.
Signal
1
BIDA+/BGND
2
BIDA-/BGND
3
BIDB+/-48 V
4
BIDC+/BGND
5
BIDC-/BGND
6
BIDB-/-48 V
7
BIDD+/-48 V
8
BIDD-/-48 V
Arrange the core wires according to the pin assignments and cut them
neatly (exposing a length of 12 mm).
8: brown
7: white and brown
6: green
5: white and blue
4: blue
3: white and green
2: orange
1: white and orange
Length of each exposed core wire: 12 mm
12 mm
Function
Bidirectional data wire A (+)/Power ground
Bidirectional data wire A (-)/Power ground
Bidirectional data wire B (+)/-48 V power signal
Bidirectional data wire C (+)/Power ground
Bidirectional data wire C (-)/Power ground
Bidirectional data wire B (-)/-48 V power signal
Bidirectional data wire D (+)/-48 V power signal
Bidirectional data wire D (-)/-48 V power signal
Advertisement
