Advertisement
Quick Links
INSTRUCTION MANUAL
COLOUR VANDAL DOME CAMERA
About this manual
Before installing and using the camera, please read this manual
carefully. Be sure to keep it handy for later reference.
Dimensions : mm
TROUBLESHOOTING
Before sending the camera out for repair, check the items
below. If the problem persists after checking these items,
contact your service center.
■ If no image appears
Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (with the level volume) ?
Is there adequate illumination?
■ If the image is unclear
Is the lens in focus?
Is the lens dirty?
Dirt of fingerprints on the lens can adversely affect the
images. Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?
WARNING:
TO PREVENT THE RIST OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
PRECAUTIONS
■ Do not open or modify
Do not open the cabinet except during maintenance and
installation, as it may be dangerous and cause damages.
■ Do not put objects inside the unit
Make sure that no metal objects or flammable substances
get inside the camera. It could cause fire, short-circuits or
damages.
■ Be careful when handling the unit
To prevent damage, do not drop the camera or subject
it to strong shock or vibration.
■ Install away from electric or magnetic fields
■ Protect from humidity and dust
■ Protect from high temperature
Be careful when installing close to the ceiling , in a kitchen
or boiler room, as the temperature may raise to high levels.
■ Cleaning
Dirt can be removed from the cabinet only by wiping it
with a soft cloth moistened with a soft detergent solution.
■ Mounting Surface
The mounting surface material must be strong enough to
secure the camera.
CONNECTOR AND CAMERA SETTING
■ CONNECTIONS
DC12V / AC24V
DC12V / AC24V
CAUTION :
Check for polarity when using a DC 12V or AC 24V power
Advertisement
Related Manuals for Ganz ST135-90-CB55H-CK-18IR-AC3
Summary of Contents for Ganz ST135-90-CB55H-CK-18IR-AC3
- Page 1 PRECAUTIONS INSTRUCTION MANUAL ■ Do not open or modify COLOUR VANDAL DOME CAMERA Do not open the cabinet except during maintenance and installation, as it may be dangerous and cause damages. ■ Do not put objects inside the unit Make sure that no metal objects or flammable substances get inside the camera.
- Page 2 CONNECTIONS AND CAMERA SETTINGS ■ LENS ADJUSTMENTS 1. Adjust the panning(360˚) and tilt(70˚) position. 2. Setting the zoom position by using Zoom Lever Screw. 3. Setting the focus by using Focus Lever Screw. ■ CAMERA SETTINGS for CB55H-Interface board (1) BLC (2) ME/AE (3) AWB (4) AGC...
- Page 3 SPECIFICATION MODEL COLOUR VANDAL DOME CAMERA ST135-90-CB55H-CK-18IR-AC3 General Spec NTSC CCD T y p e 1/3" 410K Pixels Color 1/3" 470k Pixels Color T o t a l n u mb e r o f p i x e l s...
- Page 4 (5) Adjusting level volume If the entire image is too dark or bright, or the backlight compensation is not correct even after (1) is set to "ON", you need to adjust the level volume. CCW (Low) Closes the lens iris, making the entire image darker CW(High) Opens the lens iris, making the entire image drighter (6) SECOND VIDEO OUT CONNECTOR...