Ptt To A Single Handset - VTech DECT 6.0 IS6100 User Manual

Telephone operation

PTT to a single handset

1. You have four ways to begin a PTT call:
If you have two handsets, press and hold PUSh TO TALK when the
•
handset is not in use.
Press PUSh TO TALK when the handset is not in use. Then use the
•
dialing keys to enter the destination handset number.
• Press PUSh TO TALK when the handset is not in use. Press /
or /
VOL CID
/SELECT or PUSh TO TALK.
MENU
a) Press MENU/
•
b) Press /
/SELECT.
MENU
c) Select the destination handset number by pressing /
/
VOL CID
d) Press
MENU
Your handset displays Connecting to hANDSET X... for a few seconds.
When the connection is made, both your and the destination handsets
display Press and hold [PTT] to talk and beep once.
Press and hold PUSh TO TALK on your handset. A chirp indicates your
2.
microphone is on. Speak towards the handset. Your voice is broadcast to
the destination handset.
While you are speaking, your handset displays PTT To hANDSET X (X
represents the destination handset number).
Release PUSh TO TALK after speaking. Both handsets beep once again.
3.
After the handsets beep, you can press and hold PUSh TO TALK to
continue speaking or the destination handset can respond (see Answer
PTT on page 35).
To end the PTT call, press OFF/
4.
telephone base or charger. The handset displays Push to talk Ended
for a few seconds.
After PUSh TO TALK is released, the PTT call remains open for a short
time. If no one presses PUSh TO TALK within 10 seconds, the PTT call
ends automatically.
to highlight the destination handset number and then press
when the handset is not in use.
SELECT
/
or
VOL VOL CID
or by using the dialing keys.
/SELECT or PUSh TO TALK.
to highlight > Push to talk, then press
or place the handset in the
CLEAR
33
VOL
or
VOL