Quick start guide
for models LS6325/LS6325-2/LS6325-3/
LS6325-4/LS6325-5/LS6326-5
Install the telephone base and
charger(s)
Install the telephone base and charger(s) as
shown below.
Telephone
Telephone
wall jack
base power
adapter
If you have
DSL high
speed
Electrical
Internet
outlet not
service, a
controlled by
DSL filter (not
a wall switch
included) is
required.
Telephone
line cord
Charger
Telephone base
•
Use only the power adapters and batteries
supplied with your VTech telephone.
•
For complete feature instructions, please
refer to your user's manual.
Battery installation and charging
Install the battery as shown below. After
installing the battery, you may be able to make
and receive short calls. For best performance,
charge the handset battery for at least 16 hours
before use.
1
2
Plug the battery
If the battery
connector securely
compartment cover is on
the handset, press on the
into the socket inside
the handset battery
indentation and slide the
compartment, matching
cover to remove.
the color-coded label.
Charger
adapter
4
3
Place the battery with
Align the cover flat
the label THIS SIDE UP
against the battery
facing up and the wires
compartment, then slide
inside the battery
it towards the center of
compartment.
the handset until it clicks
into place.
5
Charge the handset by
placing it in the telephone
base or charger. The
CHARGE light is on when
the handset charges.
Make, answer and end a call
Make a call
1.
Press
/
or
FLASH
You hear a dial tone.
2.
Dial the number.
Make a predial call
1.
Dial the number.
2.
Press
or
/
FLASH
Answer a call
Press
,
or any of the dialing keys
/
FLASH
(
-
,
).
0
9
#,
TONE
End a call
Press OFF/
or put the handset in the
CLEAR
telephone base or charger.
CHARGE
light
Push to talk (PTT)
You can directly broadcast messages from one
handset to the speakerphone of one or all other
.
handsets. Any handset you call can respond by
pressing PUSH TO TALK to begin a two-way
communication.
When the connection is made, both the caller
and the destination handsets display Press
and hold [PTT] to talk and beep once.
Only one handset can be talk at a time. To do
.
so, press and hold PUSH TO TALK.
For complete PTT instructions, please refer
to your user's manual.