Motor Test; Firmware - Canon imageFORMULA P-208 Service Manual With Parts Catalog

3. Motor test

This mode is used to check the feed
motor operation. When the resolution and
mode are set, and the [Start] is selected, the
motor turns according to the setting. Se-
lecting [Start] again causes the motor stop.
Figure 5-243
Message
Main motor Start
Resolution [dpi] 100/200/300/400/600
Gray/Color
Mode
Direction Forward
Note: Initial values are underlined.
Table 5-203
COPYRIGHT © CANON ELECTRONICS INC. 2012
Options
CANON P-208 FIRST EDITION
CHAPTER 5 TROUBLESHOOTING
D. Firmware
There are two methods for updating the
firmware: One is to select and execute
pre-registered firmware, and the other is to
select and execute firmware saved on the
computer. The methods using pre-registration
makes it possible to store all of the firmware
within the same folder and attach comments
to firmware, and is easy to manage.
Figure 5-244
Note: For details on firmware updates, refer
also to the separately issued service
information.
5-23