Eject Roller [Follower] - Canon imageFORMULA P-208 Service Manual With Parts Catalog

CHAPTER 3 DISASSEMBLY & REASSEMBLY

4. Eject Roller [Follower]

1) Remove the upper reading unit.
(Page 3-4)
2) Push in the document pressure
move the separation pad
screws 3 (self-tapping, BH M2.5x6).
Figure 3-209
3) Unhook two pairs of fitting parts
document pressure. Hold the reinforcing
plate in the direction of the arrow, un-
2
hook the fitting parts
the top cover (base)
Figure 3-210
Note: If the reinforcing plate is not held, the
follower roller holder may come out.
Perform the work while holding the re-
inforcing plate.
When the top cover (base) is removed,
the center spring and light guide are
detached.
3-6
1 , re-
2 and remove 2
for the
1
, lift and remove
3
.
4
COPYRIGHT © CANON ELECTRONICS INC. 2012
4) Hold the follower roller
the reinforcing plate
the arrow, and remove the follower roller
holder 3 .
Figure 3-211
5) Pull out the shaft and remove the two
registration rollers
Figure 3-212
1 by hand, slide
2 in the direction of
1 and the spring 2 .
CANON P-208 FIRST EDITION