Installing The Software; Connecting To A Computer - Canon imageFORMULA P-208 Service Manual With Parts Catalog

CHAPTER 4 INSTALLATION & MAINTENANCE

3. Installing the Software

Install the following software from the
supplied setup disk that is required in order
to use the scanner.
• CaptureOnTouch
• Scanner driver
• Others
Note: If "CaptureOnTouch Lite" is used, the
above software does not need to be
installed.
Note: The software should be installed be-
fore connecting the machine to a
computer.
The following shows an outline of the
installation on Windows.
1) Login using an account with Administrator
privileges.
2) Before installing the software, exit all other
applications.
3) Load the setup disk into the DVD drive of
the computer.
4) The setup menu starts automatically.
5) Click [Typical Installation].
Figure 4-101
Finish the installation by following the
on-screen messages.
4-2

4. Connecting to a Computer

1) Close the pickup tray and turn the Auto
2) Connect the machine and the computer
3) Open the pickup tray and verify that the
Note: The scanner cannot be used when it is
COPYRIGHT © CANON ELECTRONICS INC. 2012
Start switch "OFF".
using the supplied USB cable.
Figure 4-102
power is switched ON.
connected to a computer via a
bus-powered USB hub. A self-powered
USB hub can be used, but operation is
not guaranteed.
CANON P-208 FIRST EDITION