Canon imageFORMULA P-208 Service Manual With Parts Catalog page 81

3) Paper size is basically A4 size or LTR size,
and the above-mentioned shading sheet,
and must have the following range: Width:
200 to 220 mm; Length: 130 to 297 mm.
4) To cause neither jams nor skews.
Example: Blacken the leading edge of a A4
size or LTR size paper with a black
pen.
Use the sheet after the ink has dried.
Do not use a pencil.
The shading sheet may be used.
"A4 or LTR"
"Shading Sheet"
TKM-0326/0332
Figure 5-222
Note: If it stops in the middle when using A4
size or LTR size paper due to the
computer specifications, set to half the
size. Note that you should cut that
paper perfectly straight without any
slant.
COPYRIGHT © CANON ELECTRONICS INC. 2012
Black part 20 mm
Black
part
5 mm
Black
part
5 mm
Black part 20 mm
CANON P-208 FIRST EDITION
CHAPTER 5 TROUBLESHOOTING
Operation Procedure
1) Clean feed path, roller, and reading glass.
2) Load a piece of the registration sheet you
prepared. Make sure to set the document
guides to fit the sheet to prevent skews.
Note: The black edge needs to be detected
as the leading edge of the sheet with
the front side sensor. Load the sheet
with the black-lined side facing down,
considering this black edge of the
sheet is the top of feed. Do not set
extra sheets.
Front
Back
Figure 5-223
3) On the Information screen, select [Regis-
tration (Auto)].
Figure 5-224
Back
5-15