Note: When the Auto Start switch is "ON",
the "Auto Play" screen appears, and it
should be closed.
Figure 5-208
How to finish
Either select [ : Close] on the operation
screen or select [Exit Application] from
the [File] menu in the toolbar.
However, if "Firmware version up" is
performed, remove and reinstall the USB
cable at the end to reset the power properly.
Refer to the " Firmware version up "
section for the details.
COPYRIGHT © CANON ELECTRONICS INC. 2012
4. Application Information
This mode is used to check the detailed
version of the service mode software (EXE
file).
Select [Help] from the toolbar at the top
of the screen and then select [Application
information].
CANON P-208 FIRST EDITION
CHAPTER 5 TROUBLESHOOTING
Figure 5-209
5-9