Advertisement
Procedure
7
8
9
10
11
1
Doing the Pre-Installation
Setup
No Parts Required
Procedure
Note: If you will be installing the spring tine toolbar, install
the pivot tube brackets supplied with the spring tine toolbar
instead of the ones supplied with this attachment. Refer to the
Spring Tine Toolbar Installation Instructions for more information.
Note: When installing a front manual blade in conjunction
with a midmount toolbar system, install the midmount
toolbar system first.
Description
Lever assembly
Bolt (5/16 x 2 inches)
Locknut (5/16 inch)
Pivot tab
Toolbar link
Carriage bolt (3/8 x 1-1/4 inches)
Spacer
Washer (1 inch)
Locknut (3/8 inch)
Pedal lever assembly
Retaining ring
Washer (7/8 inch)
Bolt (5/16 x 1 inch)
Eccentric bolt
No parts required
No parts required
Shim (Part no. 110-7379)
Shim (Part no. 110-7380)
Shim (Part no. 110-7381)
No parts required
Qty.
1
1
3
1
1
1
1
Install the toolbar lift pedal.
1
1
1
2
1
1
1
Adjust the pivot spring tension and the
–
adjustable rod assembly.
–
Adjust the toolbar transport height.
1
1
Level the toolbar.
1
–
Read/store the documentation.
2
Installing the Scarifier
Lift-handle Assembly
Parts needed for this procedure:
2
Bolt (5/16 x 2-1/4 inches)
2
Nut (5/16 inch)
1
Scarifier lift-handle assembly
2
Bolt (1/2 x 3-1/4 inches)
2
Thin locknut (1/2 inch)
1
Detent plate
1
Knob
Procedure
1. Block up the rear of the machine and remove the rear
tires.
Note: Place the blocks under the rear wheel motor
mounts.
2. Remove the 4 flange-head screws that secure the
right-hand wheel shroud to the frame (Figure 1).
2
Use
Advertisement
