Loose Parts; Installing The Anti-Siphon Fill Receptacle - Toro multi-pro 1200 Operator's Manual

Loose Parts

Note: Use the chart below to verify that all parts have been shipped.
Description
90 degree fitting
Quick coupler
Hose adapter
Fill receptacle bracket
Flange nut, 5/16 inch
Hairpin cotters
Spray Pro Monitor
Bracket
Flange-head bolt, 3/4 inch
Flange nut, 1/4 inch
Knob
Washer
Carriage bolt
Key
Operator's Manual
Engine Operator's Manual
Operator Video
Parts Catalog
Registration Card
Predelivery Inspection Form
Installing the Anti-siphon Fill
Receptacle
1. Remove the rubber cap from the stud on the tank strap
(Fig. 2).
4
1
2
Figure 2
1. Fill receptacle bracket
2. Stud
3. Flange nut, 5/16 inch
Qty.
1
1
1
1
1
2
1
1
2
2
2
2
2
2
1
1
1
1
1
1
5
6
3
1865
4. 90 degree elbow fitting
5. Quick coupler
6. Hose adapter
11
Use
Install the anti-siphon fill receptacle.
Install the Spray Pro monitor.
Use in the ignition switch.
Read before operating the machine.
Watch before operating the machine.
Use for ordering replacement parts.
Complete and return to Toro.
Complete and file in your customer history portfolio.
2. Place the fill receptacle bracket over the stud and secure
it with a flange nut (5/16 inch) (Fig. 2).
3. Place the threaded end of the 90 degree elbow fitting
through the bracket and thread the quick coupler onto it,
securing it to the bracket (Fig. 2).
Note: Install the fitting with the open end pointing toward
the tank opening so the water will arc into the tank when
you fill it.
4. Install the hose adapter into the quick coupler (Fig. 2).
5. Lock the adapter into place by swinging the levers
toward the adapter and then secure them with the
hairpin cotters.