Advertisement
5
Installing the Screen Panel
and Saddles
Parts needed for this procedure:
1
Screen panel
2
Pan-head screw (#10 x 1/2 inch)
1
Right-hand saddle assembly
1
Left-hand saddle assembly
4
Bolt (5/16 x 1 inch)
4
Locknut (5/16 inch)
Procedure
Note: If you removed the manual plow, install it at this time.
1. Install the new screen panel to the back side of the
frame opening with 2 pan-head screws (#10 x 1/2
inch) (Figure 9).
G017979
1. New screen panel
2. Loosely attach the rear of a saddle assembly to each lift
arm with a bolt (5/16 x 1 inch) and a locknut (5/16
inch).
Note: The saddle stud should point inward (Figure
10).
Note: Position the saddles as shown in Figure 10.
1
Figure 9
2. Pan-head screws (#10 x
1/2 inch)
1. Bolt (5/16 x 1 inch)
2. Saddle
6
Installing a Toolbar
Parts needed for this procedure:
1
Toolbar (sold separately)
Procedure
Important: If you are installing a spring tine toolbar,
skip this procedure and install it using the instructions
provided with the toolbar. Once installed, go to
Installing the Toolbar Lift Pedal in these instructions.
Note: If your toolbar comes without the pivot bracket
installed, install it to the fourth tooth from the left as shown
in Figure 11, and tighten the bolt and nut so that the bracket
and tooth are secure before proceeding.
2
6
Figure 10
3. Lift arm
4. Locknut (5/16 inch)
Advertisement
