Table of Contents
Advertisement
Figure 20
1. Mixer tee assembly
2. Boom solenoids
3. Plug the harness connectors into the boom solenoids
at the mixer tee assembly. Plug the connector with
the blue wire to the right solenoid and plug the
connector with the orange wire to the left solenoid
(Figure 20).
Workman 200 Spray System
1. Locate the wiring harness and make the connections
to the compressor and the solenoid located at the
foam tank/compressor assembly (Figure 21).
Note: Both of the plug connections are identical
(Figure 21).
Figure 21
1. Wiring harness
2. Compressor
2. Locate the connectors in the rear wiring harness of
the sprayer (Figure 22).
A. Plug the connector with the yellow/blue wire
into the left boom solenoid.
B. Plug the connector with the blue/green wire into
the right boom solenoid.
3. Wiring harness
3. Solenoid
1. Mixer tee assembly
2. Boom solenoid, right
3. Route the hoses along the wiring harness to the rear
of the sprayer and to the mixer tee using the cable
ties. Secure the hose end with a small hose clamp.
4
Installing the Switches and
Fuse
Parts needed for this procedure:
2
Rocker switch
1
Fuse, 15-amp
Procedure
Multi Pro 1200 or 1250 Turf Sprayer
1. Remove the spray control panel to expose the
bottom side.
2. Lift and remove the 2 plugs from the spray control
panel on the vehicle and install the 2 rocker switches
provided in their place (Figure 23 for the 1250 and
Figure 24 for the 1200).
9
Figure 22
3. Boom solenoid, left
4. Wiring harness
Advertisement
Table of Contents
