Toro 41228 Installation Instructions Manual page 4

1. Compressor hose
2. Needle valve hose
5. Connect the marked supply hose to the hose barb
at the compressor and the other supply hose to the
hose barb on the needle valve (Figure 3).
6. Secure the hose ends with small hose clamps.
7. Route both of the supply hoses rearward along the
right side of the sprayer to the rear of the machine
following the sprayer wiring harness.
8. Attach the cover to the tank/compressor assembly
using 4 hex-head bolts (1/4 x 1 inch) and 4 flat
washers that you removed previously.
9. Install the tank/compressor assembly to the
Multi-Pro 1200 series adapter bracket using 2 bolts
(3/8 x 1 inch), 2 flat washers (3/8 inch) as shown
Figure 4.
1. Tank/compressor
assembly
2. Multi-Pro 1200 series
adapter bracket
Figure 3
3. To the mixer tee
Figure 4
3. Bolt (3/8 x 1 inch)
4. Flat washer (3/8 inch)
Multi Pro 5600/5700 Turf Sprayer
1. Remove 4 bolts (1/4 x 1 inch) and flat washers that
hold the cover to the tank/compressor assembly
(Figure 5).
1. Cover
2. Tank/compressor
assembly
3. Flat washer
2. Remove the cover.
3. Set the cover and fasteners aside.
4. Mark a 108 inch supply hose with a black marker at
each end (Figure 6).
1. Compressor hose
2. Needle valve hose
5. Connect the marked supply hose to the hose barb
at the compressor and the other supply hose to the
hose barb on the needle valve (Figure 9).
6. Secure the hose ends with small hose clamps.
7. Route both of the supply hoses rearward along the
left side of the sprayer to the rear of the machine
following the sprayer wiring harness.
4
Figure 5
4. Bolt (1/4 x 1 inch)
5. Bottom right bolt
Figure 6
3. To the mixer tee