Toro 41228 Installation Instructions Manual page 5

8. Mount the tank/compressor assembly to the right
step frame using 2 bolts (3/8 x 1 inch) and 2 flat
washers (Figure 7).
1. Right step frame
Note: You must install the fasteners from the
backside of the step frame.
9. Attach the cover to the tank/compressor assembly
using 4 hex-head bolts (1/4 x 1 inch) and 4 flat
washers that you removed previously.
Workman 200 Spray System
1. Remove the 4 bolts (1/4 x 1 inch) and 4 flat washers
that hold the cover to the tank/compressor assembly
and remove the cover (Figure 8).
1. Cover
2. Tank/compressor
assembly
3. Flat washer
2. Set the cover and fasteners aside.
3. Mark a 108 inch supply hose with a black marker at
each end (Figure 9).
Figure 7
2. Tank assembly frame
Figure 8
4. Bolt (1/4 x 1 inch)
5. Bottom right bolt
1. Compressor hose
2. Needle valve hose
4. Connect the marked supply hose to the hose barb
at the compressor and the other supply hose to the
hose barb on the needle valve (Figure 9).
5. Secure the hose ends with small hose clamps.
6. Route both of the supply hoses rearward along the
left side of the sprayer to the rear of the machine
following the sprayer wiring harness.
7. Remove the rubber striping on the back side of the
tank cover (Figure 10).
1. Rubber strip
2. Tank cover
3. Mud flap bracket
8. Locate the mud flap and mud flap bracket in loose
parts. Install the mud flap to the tank cover. Secure
the flap using the bracket, three bolts (5/16 x 3/4
5
Figure 9
3. To the mixer tee
Figure 10
4. Mud flap
5. Bolt (5/16 x 3/4 inch)
6. Locknut (5/16 inch)