Toro 41228 Installation Instructions Manual page 6

inch) and three locknuts (5/16 inch) as shown in
Figure 10.
9. Attach the cover to the tank/compressor assembly
using 3 of the 4 hex-head bolts (1/4 x 1 inch) and
flat washers that you removed previously. Leave the
bottom right bolt out until later in the installation
(Figure 8).
10. Mount the Workman adapter bracket supplied in the
kit to the tank/compressor assembly using 2 bolts
(3/8 x 1 inch), 2 flat washers (3/8 inch) as shown
Figure 11.
Note: If necessary, cut back the rubber trim on the
cover so that it does not interfere when mounting
the bracket to the tank/compressor assembly.
1. Workman adapter bracket
2. Tank/compressor
assembly
3. Bolt (3/8 x 1 inch)
11. Install the remaining bolt (1/4 x 1 inch) and flat
washer (1/4 inch) through the Workman adapter
bracket and cover into the tank/compressor
assembly (Figure 11).
12. Remove the left handle and fasteners from the left
side of the tank skid. Save fasteners for later use.
13. Mount the foam marker assembly to the frame using
two bolts (3/8 x 1 inch), two washers (3/8 inch), two
flange nuts (3/8 inch) included in loose parts; and
the left handle and fasteners removed previously
(Figure 12).
Note: Rotate the tank so that the handle is closest
to the frame.
Figure 11
4. Flat washer
5. Bolt (1/4 x 1 inch)
6. Flat washer (1/4 inch)
1. Foam marker assembly
2. Frame
3. Bolt (3/8 x 1 inch)
4. Washer (3/8 inch)
2
Installing the Mixer Tee
Parts needed for this procedure:
1 Bolt (3/8 x 1 inch)
1 Locknut (3/8 inch)
1 Mixer assembly
2 Flat washer (3/8 inch)
Procedure
For all sprayers, serial number 259999999 and lower
1. At the rear of the machine, mount the mixer
assembly facing rearward to the bracket on the
center boom assembly with a bolt (3/8 x 1 inch), flat
washer, and locknut (Figure 13).
6
Figure 12
5. Flange nut, serrated (3/8
inch)
6. Left sprayer handle
7. Fasteners