Vehicle Installation - Wilson Electronics SIGNALBOOST Sleek 2B5225 Installation Manual

Vehicle Installation

1. Install the Outside Antenna
To receive the best cell signal, select a location for the outside antenna that is preferably in the center of
the vehicle's roof, 12 inches away from any other antennas, free of obstructions, and at least 6 inches
from the rear or side windows or sunroof.
Mini Magnet-
Mount Antenna
Shown
The outside antenna must be installed vertically.
Antenna performance will be degraded if the antenna
is not vertical.
The antenna cable is small yet strong enough that it
may be shut in most vehicle doors without damaging
the cable.
RF Safety Warning: The "outside antenna" must be either a Wilson Magnetic-Mount or Mini Magnetic-
Mount antenna and requires at least an 8 inch separation distance from all persons. Other outside
antennas may be used with fixed building installations provided that (a) they are located with at least a 30
inch separation distance from all persons, (b) their gain less cable loss does not exceed 15 dBi, and (c)
they are not operating in conjunction with any other antenna or amplifier.
2. Attach the Mounting Bracket
A mounting bracket is provided for attaching the Sleek™ to your vehicle's dash. Other options are also
available from Wilson Electronics.
3
For free U.S. based technical support or to order accessory items please call
For a more professional-looking installation, the antenna
cable may be run under the door seal. Carefully pull down
the door seal. Run the cable under the seal and push
the seal back into place. This prevents constant wear
and tear on the cable as the door opens and closes. The
antenna cable is small enough to easily tuck under the
door seal or plastic molding.
ADHESIVE BRACKET- Included in this package
1.Clean the area where the bracket is to be mounted with the alcohol wipe
provided. Allow to dry.
2. Peel the backing to expose the adhesive and press the bracket onto
the desired location in the vehicle. Note: be sure the tab is positioned
vertically, not horizontally.
3. Allow the adhesive to cure for 24 hours before you attach the Sleek™.
4. Once the cradle is attached, you can adjust the angle of the adhesive
bracket by applying gentle pressure to the top or bottom of the Sleek™.
The bracket is designed to swivel when the knurled nut is loosened for
greater adjustability of the Sleek™ viewing angle. To lock bracket into
position, tighten large nut.
800-204-4104 or visit www.wilsonelectronics.com
Carefully
Pull Down
Door Seal
Run Cable
Under Seal