INSTALLATION
18. Connect the main power harness, pairing
button harness, and the mini-tuner to the
interface module. Attach the XM mini-
tuner to the interface module using the
supplied
2 1/4" x 2 1/4" adhesive pad.
19. Wrap the module with the supplied large
foam pad, ensuring that the connector
ports are left accessible.
20. Connect the main power harness, pairing
button harness, and the mini-tuner to the
interface module. Attach the XM mini-
tuner to the interface module using the
supplied large foam pad.
21. Secure the XM mini-tuner and interface
module to the brace located to the left
side of the radio mounting location.
22. Apply the supplied piece of 1x1 double
sided tape to the bottom side of the pair-
ing button.
23. Route the pairing button towards the
glove compartment mounting location.
Peel the protective backing off of the
double side tape and attach the pairing
button to mounting location.
24. Using a 1/8" drill bit, pre drill holes in the
mounting slots. Then use the supplied
screws to secure the pairing button to the
upper left corner of the glove compart-
ment, approximately 1" from the side.
Southeast Toyota Distributors, LLC
FR-S 2015
Page 10 of 16
XM Satellite Radio
Adhesive Pad