Dantherm DanX XWPRS Series User Manual page 31

6. FAULTFINDING
1)
If the frost thermostat is manual, it must be you have to reset before starting the unit.
The thermostat is located in the compartment (1) above the LPHW heating coil.
2)
The fire thermostat must be reset before the unit is started again. Press the red button on
the thermostat to reset.
The thermostats are located in the exhaust (70°C thermostat) and supply (40°C) air.
3)
For further explanations see the manual of the frequency inverter.
4)
The HP pressostat has to be reset before the compressor can start again. The red reset
button (2) is placed near the compressors inside the XWPRS module.
1
2
29