Modules Above Each Other; Half Height Hanging Filter Modules - Dantherm DanX XWPRS Series User Manual

3. INSTALLATION

3.2.2 Modules above each other

After the installation of the bottom modules (se chapter 3.2.1) the halve height top modules
can be placed above the bottom modules in the following way.
•
Lift the module with a fork lift and push the module from the wooden pallet onto the
bottom module.
•
Use a strap to get the modules as close together as possible. Straps should only be
mounted at the bottom or/and top of the modules
•
Use the assembly rails as described in chapter 3.2.1, not only vertical but also horizontal
to connect the upper module with the module below.

3.2.3 Half height hanging filter modules

Half height hanging filter modules are mounted on a set of support brackets (to be found in a
box inside the module).
Follow these steps for mounting the modules:
•
Screw the two brackets into the end frame of the DanX unit, by using the bolts delivered
with the brackets.
•
Lift the filter module onto the brackets
•
Fasten the filter module with the assembly rails to the top and side of the DanX. The
assembly rails can only be used on three sides and not beneath the module.
•
Use the self-cutting screws to fasten the filter module to the support brackets.
Important:
If the module is longer than 880 mm or contains other functions than a filter, the module must
be supported at the free end of the module, to avoid that the module sinks.
This supporting is not included in the delivery.
9